SPECIAL GRINDING

Hypersoft

Edge reduction for plus lenses with a soft overlap from optical zone to carrier. The optical zone will be adjusted according to power and frame shape.
Available on all lenses except RS28.

Myosoft

Edge reduction for minus lenses with a soft overlap from optical zone to carrier. The optical zone will be adjusted according to power and frame shape.
Available on all lenses except RS28.

Myolenti

Edge reduction for minus lenses with a sharp overlap from optical zone to convex carrier. The optical zone will be adjusted according to power and frame shape.
Available on all Classic lenses. Recommended for higher powers than Myosoft.

Combi cylinder

Optimization of lenses with high cylinder. The cylinder power is divided on both sides of the lens. Gives a higher optical quality and better aesthetics.
Available on all white lenses in index 1.5, 1.6 and 1.67.

Biconvex / Biconcave

A biconvex or biconcave grinding.
Biconvex: Available on all Classic lenses.
Biconcave: Available on all white Classic lenses.

Formlenti

Edge thickness reduction through cutting lens material away based on the shape of the frame.
Available on all lenses.

ML Grand

A grinded image magnifier of 1-9 %. For balancing aniseikonia (one lens) or for achieving a small amount of magnifying effect (both lenses). Note that due to limited range of blank thickness and curves, high magnification is not always possible.
Available on all lenses.

Slab-off

Prismatic grinding used to balance anisometropia. Slab-off is applied only to half of the lens. In general, the lower part of the lens with most minus/least plus gets a base up prism.
Available on all lenses.

Balance lenses

It’s possible to order a balance lens at a reduced cost. Just put a note about balance lens on the order. This means that deviation from ordered pd and small defects on the surface is allowed.

We are using Cookies to give you a superior user experience. Futher browsing of this site indicates that you accept our cookie policy.